Compilation and installation of CWB version 2.2.104, tested on Ubuntu 9.10 (Karmic Koala)

You just need a working linux installation. If you're using a “desktop” linux installation (such as Ubuntu), you may need to install the following packages:

• autoconf
• bison
• flex
• gcc
• libc6-dev
• libglib2.0-dev
• libncurses5-dev
• make
• subversion

So, in case they are not installed, all you have to do in Ubuntu is:

sudo apt-get install autoconf bison flex gcc libc6-dev libglib2.0-dev libncurses5-dev make subversion

Get the source code using subversion, see this page for instructions.

Enter the new directory:

cd cwb-3.0

First you need to include the right platform in config.mk using your favorite editor, we used nano:

nano -w config.mk

Change the line:

include $(TOP)/config/platform/darwin-universal

to:

include $(TOP)/config/platform/linux

or

include $(TOP)/config/platform/linux-64

or

include $(TOP)/config/platform/linux-opteron

This section of the file should now look like this:

[...]
# PLATFORM-SPECIFIC CONFIGURATION (OS and CPU type)                                                                     
#                                                                                                                       
# Pre-defined platform configuration files:                                                                             
#       unix            standard Unix configuration [must set ENDIAN manually!]                                         
#       linux           i386-Linux (generic)                                                                            
#         linux-64       - configuration for 64-bit CPUs                                                                
#         linux-opteron  - with optimimzation for AMD Opteron processor                                                 
#       darwin          Mac OS X / Darwin [use one of the CPU-specific entries below]                                   
#         darwin-g4      - with optimization for PowerPC G4 processor                                                   
#         darwin-g5      - with optimization for PowerPC G5 processor                                                   
#         darwin-i386    - configuration for i386-compatible processors                                                 
#       solaris         SUN Solaris 8 for SPARC CPU                                                                     
#       cygwin          Win32 build using Cygwin emulation layer (experimental)                                         
#                                                                                                                       
include $(TOP)/config/platform/linux
[...]

Next compile the different components, one at a time. First clean and check dependencies:

make clean
make depend

Then compile the corpus library:

make cl

Now editline

make editline

Then utilities

make utils

Finally compile cqp:

make cqp

Now we're ready to install the whole toolkit:

sudo make install